ここから本文です
TWO:
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:"Of course!" he said; "of course! But, Smith, my mind was so full--just for the moment, you know,--of her we were speaking of in connection with Ned Ferry--Do you know? she's so unprotected and tagged after and talked about that it seems to me sometimes, in this nervous condition of mine, that if I could catch the entire gang of her pursuers in one hole I'd--I'd end 'em like so many rats. That sort of feeling is mere impulse, of course," he went on, "and only shows how near I am to that nervous breakdown. Yes, the Harper ladies are mighty lovely and hard enough to leave, but that's all I meant to you, and I'm sorry I touched your feelings. I'm tchagrined. Anyhow, all this is between us, you know. I wouldn't ever have confessed such feelings as I did just now except to a friend who knows as well as you do that if I ever should do a man a mortal injury I wouldn't do it in a spirit of resentment. You know that, don't you? No, that's not my way--Why, Smith, what gives you those starts? That's the third time you've done that this morning."

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:"We went near the prison while we were in the Tartar city, and so it was proposed that we should see what there was inside. It was the most horrible place I have ever seen, and the wonder is that men can be found inhuman enough to condemn people to be shut up there. There was a large cage so full of men that there was not room on the floor for them all to lie down at once, even if they had been as close together as sardines in a can. We could see through the bars of the cage, as if the captives had been wild animals instead of human beings, and they looked so worn and wretched that we all pitied them very much. If a man is sent to prison in China,[Pg 372] and has no money to pay for his food, he will die of starvation, as the jailers are not required by law to feed the prisoners under their charge. There were men chained, with iron collars around their necks; and others tied, with their hands and feet brought close together. The suffering was terrible, and we were glad to come away after a very few minutes. It is positive that we do not want to see another prison as long as we stay in this country.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:I was met in the bare unpainted hall by a dropsical man of nearly sixty, holding a dim candle, a wax-myrtle dip wrapped on a corncob. He had a retreating chin, a throat-latch beard and a roving eye; stepped with one foot and slid with the other, spoke in a dejected voice, and had very poor use of his right hand. I followed him to the rear corner chamber, the one nearest the stable, feeling that, poor as the choice was, I should rather have him for my robber and murderer than those villains down at the quarters. I detained him in conversation while I drew off my boots and threw my jacket upon the back of a chair in such a way as to let my despatch be seen. The toss was a lucky one; the document, sealed with red wax, stuck out arrogantly from an inside pocket. Then, asking lively questions the while as if to conceal a blunder and its correction, I moved quickly between him and it and slipped the missive under a pillow of the fourpost bedstead.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.