ここから本文です
TWO:Cairness had made a tune for himself and was putting to it the words of the ill-fated poet of his own Land of the Dawning.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:He handed it over also.Captain Parks says no one ever was told that combination.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:They had devised a hastily planned code of signals, very much like those used by a flying school instructor giving orders to a pupil where the Gossport helmet was not worn.Cairness sat more erect, and settled down to wait. The motion was so swift that he hardly felt it. He turned his head and looked back at the flaming corrals, and, remembering the dead animals, wondered who had hamstrung them. Then he peered forward again the little way he could see along the road, and began to make out that there was some one ahead of him. Whoever it was scurrying ahead there, bent almost double in his speed, was the one who had hamstrung the mules and horses, and who had set fire to the corrals. The pony was rather more under control now. It could be guided by the halter shank.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:The stranger had a pleasant, round face, with eyes that twinkled in spite of the creases around them that showed worry. No wonder he was worried, Sandy thought: having deserted the craft they had foiled in its attempt to get the gems, the man had returned from some short foray to discover his craft replaced by another.She set about cleaning the little revolver, self-cocking, with the thumb-piece of the hammer filed away, that her husband had given her before they were married. To-night she wanted no dinner. She was given to eating irregularly; a good deal at a time, and again nothing for a long stretch. That, too, was in the blood. So she sent the soldier cook away, and he went over to the deserted barracks.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.