ここから本文です
TWO:
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:Naomi's money had been the greatest possible help. He had roofed the Dutch barn, and retarred the oasts, he had bought a fine new plough horse and a waggon, and he was going to buy another piece of Boarzellten or twelve acres this time, of the more fruitful clay-soil by the Glotten brook. Naomi was pleased to see all the new things. The barn looked so spick-and-span with its scarlet tiles, and the oasts shone like polished ebony, she loved to stroke the horse's brown, snuffling nose, and "Oh, what a lovely blue!" she said when she saw the waggon.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:"NoI d?an't say it. I did write 'em. But it's all your fault that I didso you've no right to miscall me."

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:For a moment Reuben was bewildered with his sudden waking, but he soon came to himself at the sight of his wife's distorted face and the inanimate lop-headed baby. He sprang up, pulled on his trousers, and in two minutes had bundled the half-conscious but utterly willing Beatup out of his attic, and sent him off on the fastest horse to Rye. Then he came back into the bedroom. Naomi was sitting on the floor, her hair falling over her shoulders, the baby unconscious on her lap.The little boys grew big and went to school. This time it was not to the dame's school in the village, for that had collapsed before the new board-school which had risen to madden Reuben's eyes with the spectacle of an educated populace. They went to Rye Grammar School and learned Latin and Greek like gentlemen. There was something new in Reuben's attitude towards these boys, for his indulgence had deeper roots than expediency. Sometimes of an evening he would go to the bottom of the Totease lane, where it joins the Peasmarsh road, and wait there for his sons' return. They would see him afar off, and run to meet him, and they would all three walk home together, arm-in-arm perhaps.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.