ここから本文です
TWO:"I had two years for that," Lalage went on, "two weary years which is an agony to a restless man like myself. You betrayed me, because I was in your way, and so that you could keep the spoil to yourself. You were poorer and less prosperous in those days than you seem to be now. You are rich."Prout nodded. It was some little time before the other spoke. His next question startled the detective.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:Many things had happened at Vis since my first visit. Under the pretext that the church spire could indicate to Fort Pontisse in which direction to shoot, paraffin had been poured over church and spire and fire set to them. It was a venerable ancient structure, built ten centuries ago, the fine stained windows of which were well known."It was draped or some way disguised in black. A woman sat by the driver, with a cloud of lace over her head. I could just catch a glimpse of a brass rail where the drapery was disturbed."

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:"Found anything out, mate?" another officer asked.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:It is, after all, very questionable whether human happiness would be increased by suppressing the thought of death as something to be feared. George Eliot, in her Legend of Jubal, certainly expresses the contrary opinion.180 The finest edge of enjoyment would be taken off if we forgot its essentially transitory character. The free man may, in Spinozas words, think of nothing less than of death; but he cannot prevent the sunken shadow from throwing all his thoughts of life into higher and more luminous relief. The ideal enjoyment afforded by literature would lose much of its zest were we to discard all sympathy with the fears and sorrows on which our mortal condition has enabled it so largely to drawthe lacrimae rerum, which Lucretius himself has turned to such admirable account. And the whole treasure of happiness due to mutual affection must gain by our remembrance that the time granted for its exercise is always limited, and may at any moment be brought to an endor rather, such an94 effect might be looked for were this remembrance more constantly present to our minds.This proposition argues the expediency of reducing the proportions of mill gearing and increasing its speed, a change which has gradually been going on for fifty years past; but there are opposing conditions which make a limit in this direction, such as the speed at which bearing surfaces may run, centrifugal strain, jar, and vibration. The object is to fix upon a point between what high speed, light weight, cheapness of cost suggest, and what the conditions of practical use and endurance demand.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:A planing machine with a running platen occupies nearly twice as much floor space, and requires a frame at least one-third longer than if the platen were fixed and the tools performed the cutting movement. The weight which has to be traversed, including the carriage, will in nearly all cases exceed what it would be with a tool movement; so that there must exist some very strong reasons in favour of a moving platen, which I will now attempt to explain, or at least point out some of the more prominent causes which have led to the common arrangement of planing machines.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.