ここから本文です
TWO:"It's a message to the Confederation," Norma said slowly. "I suppose it's important, and you wanted"
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:The rebels on the rocks having quieted down, the boys stowed themselves around the roots of the trees, made little fires under the shelter of the rocks, cooked their suppers, smoked their pipes, and finally rolled themselves in their blankets and went to sleep.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:"Of course they do, and very properly," said Si. "Is your engineer all right?"
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:So the late afternoon wore on. It grew very quiet all around. Even the dull booming of the cannon far up the valley where Howard and Schofield were advancing on the heavy works immediately in front of Dalton, died down into sullen fitfulness.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:"You must've bin out late last night, stranger," said the first."There you go again." Dr. Haenlingen shoved back her chair and stood up, marched to the window and stared out at the forest again. Below, the vegetation glowed in the daylight. She shook her head slowly. "How can you give me what I want when I don't know what I want? I need to know what you think, how you react. I'm not going to bite your head off if you do something wrong: there's nothing wrong that you can do. Except not react at all."
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.