THREE:Arrangement comes next; in this the first matter to be considered is convenience of manipulation. The cutting position should be so arranged as to admit of an easy inspection of the work. An operator having to keep his hand on the adjusting or feed mechanism, which is about twelve inches above the work, it follows that if the cutting level is four feet from the floor, and the feed handle five feet from the floor, the arrangement will be convenient for a standing position. As the work requires continual inspection and hand adjustments, it will for this reason be a proper arrangement to overhang both the supports for the rack and the cutting tools, placing them, as we may say, outside the machine, to secure convenience of access and to allow of inspection. [156] The position of the cutting bar, crank, connections, gearing, pulleys, and shafts, will assume their respective places from obvious conditions, mainly from the position of the operator and the work.For set squares, or triangles, as they are sometimes called, no material is so good as ebonite; such squares are hard, smooth, impervious to moisture, and contrast with the paper in colour; besides they wear longer than those made of wood. For instruments, it is best to avoid everything of an elaborate or fancy kind; such sets are for amateurs, not engineers. It is best to procure only such instruments at first as are really required, of the best quality, and then to add others as necessity may demand; in this way, experience will often suggest modifications of size or arrangement that will add to the convenience of a set.
How awesome would it be to design, while still a student, the product that would set your entire future up?