TWO:3. Two elevations taken at right angles to each other, fix all points, and give all dimensions of parts that have their axis parallel to the planes on which the views are taken; but when a machine is complex, or when several parts lie in the same plane, three and sometimes four views are required to display all the parts in a comprehensive manner.
TWO:The arrangement of patterns with reference to having certain parts of castings solid and clean is an important matter, yet one that is comparatively easy to understand. Supposing the iron in a mould to be in a melted state, and to contain, as it always must, loose sand and 'scruff,' and that the weight of the dirt is to melted iron as the weight of cork is to water, it is easy to see where this dirt would lodge, and where it would be found in the castings. The top of a mould or cope, as it is called, contains the dirt, while the bottom or drag side is generally clean and sound: the rule is to arrange patterns so that the surfaces to be finished will come on the bottom or drag side."Indeed it is, sir. A good deal better looking than the other poor fellow, but directly I set eyes upon him I couldn't fail to see the likeness. And when he took off his gloves, and showed the big orange spots, I felt certain."


















