ここから本文です
TWO:We waited in the street for two of the soldiers who went to fetch the old man. After waiting a good while the poor wretch appeared between them. He wept profusely, and between his loud sobs affirmed repeatedly that he was innocent, that he did not know me, that I told him I was a Netherland journalist, and so on, and so on: "Oh, gentlemen!oh, gentlemen!" he exclaimed, "I must not leave my little boy ... my laddie; ... he is quite alone.... Oh, let me go!" ...
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:But why did he come so far out on Long Island, and then get a dead stick so handy to this old estate that hasnt been lived in for years and that has everybody scared so they wont come near at night?
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:Professor John Sweet of Cornell University, in America, while delivering an address to the mechanical engineering classes, during the same year, made use of the following words: "It is [5] not what you 'know' that you will be paid for; it is what you can 'perform,' that must measure the value of what you learn here." These few words contain a truth which deserves to be earnestly considered by every student engineer or apprentice; as a maxim it will come forth and apply to nearly everything in subsequent practice.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:"Get up!" the latter cried. "Why do you grovel there? Faugh! you sicken me. Is there no spark of manhood in you at all? You are going to die.""Then you be after her as soon as possible," Prout groaned. "We're done, Smithers. That smart lady's-maid was Countess Lalage!"
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.