TWO:When a tool is guided by turning on points, the movement is perfect, and the straightness or parallelism of holes bored in this manner is dependent only on the truth of the carriage movement. This plan of boring is employed for small steam cylinders, cylindrical valve seats, and in cases where accuracy is essential.A drawing being inked in, the next things are tints, dimension, and centre lines. The centre lines should be in red ink, and pass through all points of the drawing that have an axial centre, or where the work is similar and balanced on each side of the line. This rule is a little obscure, but will be best understood if studied in connection with a drawing, and perhaps as well [84] remembered without further explanation.