ここから本文です
TWO:"Man," he said sternly, "that fiend of a woman was my dead wife's late companion."
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:In regard to premiums, it is a matter to be determined by the facilities that a work may afford for teaching apprentices. To include experience in all the departments of an engineering establishment, within a reasonable term, none but those of unusual ability can make their services of sufficient value to offset what they receive; and there is no doubt but that premium engagements, when the amount of the premium is based upon the facilities afforded for learning, are fair and equitable.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:We jogged on to Louvain at a rate of not quite three miles an hour. Here and there we had to wait a half or a whole hour to let trains from Brussels pass. The reason why the train went so slowly was because a week before a Belgian patrol had daringly broken through the outposts and destroyed the railway near Lovenjool. That village was then burned down completely and the vicar made a prisoner."But you evidently don't," Hetty said coolly. "I was going to give your ladyship a little information. I fancy you were present at Lytton Avenue the night of the card party when those mysterious notes were produced. It was never known exactly who paid them over to Mr. Isidore, but I know now. They came from Countess Lalage; indeed, she admitted as much to my uncle, Mr. Lawrence."
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:"I should like to hear more of this," Maitrank cried."And he is perfectly right. That wonderful man always is right. Mamie is the only child of a sister of mine who lives in Florence. I wanted her once to impoverish herself to help me in one of my schemes, and she refused. By way of revenge I had her child stolen. That is some four years ago. She never knew I had a hand in it; she deems Mamie to be dead. When I am gone I want you to write to my sister and tell her what I am saying. Only you must get the address."

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:Lawrence read over the letters carefully, there was less here than he expected. They were all full of vague schemes of making money by various shady ways, and all bewailed the fact that the writer could not obtain the necessary capital to start. Really the letters were hardly worth reading.Having assumed a certain work to do, the cutting of tooth racks ? in. pitch, and 3 in. face, the first thing to be considered will be, is the machine to be a special one, or one of general adaptation? This question has to do, first, with the functions of the machine in the way of adapting it to the cutting of racks of various sizes, or to performing other kinds of work, and secondly, as to the completeness of the machine; for if it were to be a standard one, instead of being adapted only to a special purpose, there are many expensive additions to be supplied which can be omitted in a special machine. It will be assumed in the present case that a special machine is to be constructed for a particular duty only.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.