ここから本文です
TWO:And she threw herself upon her knees before him.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:With reluctance she left Florence, but after all her supreme desire was Rome, and when at length in the distance across the plain over which they were travelling, the dome of St. Peters rose before them, she could hardly believe she was not dreaming, and that Rome lay there. Through the Porta del Popolo, across the piazza, down the Corso, and up to the entrance of the French Academy they drove, and the long journey was finished.As to Pauline, she spent her whole time in working for and visiting those unfortunate emigrs within reach who were in poverty and distress.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:Lisette now settled down into that Roman life [95] which in those days was the most enchanting that could be imagined. M. Le Brun being no longer able to take possession of her money, she had enough for everything she wanted, and in fact during the years of her Italian career she sent him 1,000 cus in reply to a piteous letter, pleading poverty; and the same sum to her mother.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:About the former, who was deeply in love with her, and most anxious to make her his wife, she did not care at all. She found him tiresome, and even the prospect of being a princess could not induce her to marry him. Besides, she had taken a fancy to the Marquis de Fontenay, whom she had first met at the house of Mme. de Boisgeloup, who was much older than herself, and as deplorable a husband as a foolish young girl could choose.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.