日少妇av_日少妇网_日日一级a看片免费_日本 三级 欧美 国产在线看片

THREE:Dimension lines should be in blue, but may be in red. Where to put them is a great point in draughting. To know where dimensions are required involves a knowledge of fitting and pattern-making, and cannot well be explained; it must be learned in practice. The lines should be fine and clear, leaving a space in their centre for figures when there is room. The distribution of centre lines and dimensions over a drawing must be carefully studied, for the double purpose of giving it a good appearance and to avoid confusion. Figures should be made like printed numerals; they are much better understood by the workman, look more artistic, and when once learned require but little if any more time than written figures. If the scale employed is feet and inches, dimensions to three feet should be in inches, and above this in feet and inches; this corresponds to shop custom, and is more comprehensive to the workman, however wrong it may be according to other standards.

FORE: FORE:5. Every part laid down has something to govern it that may be termed a "base"��some condition of function or position which, if understood, will suggest size, shape, and relation to other parts. By searching after a base for each and every part and detail, the draughtsman proceeds upon a regular system, continually maintaining a test of what is done. Every wheel, shaft, screw or piece of framing should be made with a clear view of the functions it has to fill, and there are, as before said, always reasons why such parts should be of a certain size, have such a speed of movement, or a certain amount of bearing surface, and so on. These reasons or conditions may be classed as expedient, important, or essential, and must be estimated accordingly. As claimed at the beginning, the designs of machines can only in a limited degree be determined by mathematical data. Leaving out all considerations of machine operation with which books have scarcely attempted to deal, we have only to refer to the element of strains to verify the general truth of the proposition.