THREE:Drilling, more than any other operation in metal cutting, requires the sense of feeling, and is farther from such conditions as admit of power feeding. The speed at which a drill may cut without heating or breaking is dependent upon the manner in which it is ground and the nature of the material drilled, the working conditions may change at any moment as the drilling progresses; so that hand feed is most suitable. Drilling machines arranged with power feed for boring should have some means of permanently disengaging the feeding mechanism to prevent its use in ordinary drilling.Attention has been called to this case as one wherein the conditions of operation obviously furnish true data to govern the arrangement of machinery, instead of the determinable strains to which the parts are subjected, and as a good example of the importance of studying mechanical conditions from a practical and experimental point of view. If the general diameter of a shaft is based upon the exact amount of power to be transmitted, or if the diameter of a shaft at various parts is based upon the torsional stress that would be sustained at these points, such a shaft would not only fail to meet the conditions of practical use, but would cost more by attempting such an adaptation. The regular working strain to which shafts are subjected is inversely as the speed at which they run. This becomes a strong reason in favour of arranging shafts to run at a maximum speed, provided there was nothing more than first cost to consider; but there are other and more important conditions to be taken into account, principal among which are the required rate of movement where power is taken off to machines, and the endurance of bearings.
FORE:47
Offer Available till Sunday 12 Nov 2014.
Add To Cart