ここから本文です
TWO:He went in through the gate, and was once more upon that reservation he had been commanded by the overbearing tyrant representative of the military to leave, several weeks before. As he trudged along, tattoo went. In the clear silence, beneath the sounding-boards of the low clouds, he heard the voice of one of the sergeants. He shook his fist in the direction. Tattoo being over, some of the lights were put out, but there were still plenty to guide him. He did not want to get there too early, so he walked more slowly, and when he came to the edge of the garrison, he hesitated.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:The shadow was swallowed up in darkness. The candle had been blown out, and Landor came back to the fire.The major resumed his walk and did not answer.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:"She was a captive among the Chiricahuas up in the Sierra Madre. She's had a hard time of it. That and the return march have been too much for her."Perhaps the Scripture texts had taught their lesson, or perhaps there yet lingered a hope of learning that which her husband would not tell. Anyway, for the week which the woman lay on the cot in the little whitewashed chamber, which had no outlet save through the sitting room where some one was always on guard night and day, Mrs. Taylor served her with a good enough grace.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:Felipa stood leaning listlessly against the post of the ramada, watching them. After a time she went into the adobe and came out with a pair of field-glasses, following the course of the command as it wound along among the foot-hills. The day dragged dully along. She was uneasy about her husband, her nerves were shaken with the coffee and quinine, and she was filled,[Pg 76] moreover, with a vague restlessness. She would have sent for her horse and gone out even in the clouds of dust and the wind like a hot oven, but Landor had forbidden her to leave the post. Death in the tip of a poisoned arrow, at the point of a yucca lance, or from a more merciful bullet of lead, might lurk behind any mesquite bush or gray rock.The woman shrugged her round brown shoulders from which the rebozo had fallen quite away, and dropped her long lashes. "No se," she murmured.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.